 |
Search / Sitemap
|
| INVESTMENT CASTING |
 Introduction |
| Process |
| FAQs |
| Job Handling Capacity |
| Metals / Material |
| Ferrous |
| Non-Ferrous |
| Tolerance |
| Quality Tolerance |
| General Tolerances |
| Flatness |
| Straightness |
| Concentricity |
| Roundness |
| Angles |
| Hole Positioning |
| Blind Holes |
| Parallel Sections |
| Wall Thickness |
| Round Hollow Tubing |
| Surface Finish |
Investment Casting > Tolerances > Blind Holes
Blind holes can be cast if length does not exceed the diameter. In nonferrous materials, blind holes under 2" may be cast if length does not exceed twice the diameter.
Top of Page
